Datamax Allegro 2 Manuel d'utilisateur télécharger pdf (Page 15)

Getting Started

Allegro2 7

Paper/Ribbon This light is activated when:

Light: • No label and/or ribbon is detected.

• The Internal Rewinder (if installed) is not

rotating, (i.e., maximum rewind capacity has

been reached).

Ribbon For direct-thermal printing, (no ribbon), slide the

Switch: switch to the ‘off’ position. For thermal-transfer

printing, (ribbon installed), slide the switch to the

‘on’ position.

Darkness POT: This POT is used to fine adjust the print darkness

due to variations in different media’s and

printheads.

Note: Do not use this control for adjusting individual label printing

jobs, rather, use the software control with the ALT-P Print

Parameters Screen in the Internal Batch Mode (see Section 4),

or the proper command in RS-232 mode to vary darkness of

printing on a per-label-format basis.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 114 115

Pas de commentaire

Datamax Allegro 2 Manuel d'utilisateur Page 15