Datamax I-Class Manuel de l'opérateur télécharger pdf (Page 84)

74 I-Class

C. With the printhead locked in the down position, loosen the Printhead Mounting Screw (it

will remain in the assembly).

D. Rotate the printhead latch forward and, while supporting the Printhead, raise the

Printhead Assembly. Disconnect the Cables and then remove the Printhead.

E. Install the Printhead by securely connecting both Cables.

F. Position the Printhead onto the Locating Pins in the Printhead Assembly and secure it

with the Printhead Mounting Screw. (Do not over-tighten the screw.)



Note: Printhead alignment is normally not required.

G. Clean the Printhead; see Section 5.6.1.

H. If removed, load ribbon. Lower the printhead assembly, and rotate the printhead latch

into the locked position. Plug in and turn ON the printer. Print a Validation Label (see

Section 4.3.4). If necessary, adjust the PRINT CONTROL / CUSTOM ADJUSTMENTS /

DARKNESS setting (see Section 4.2.3) so that the print contrast matches previous

levels.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 131 132

Pas de commentaire

Datamax I-Class Manuel de l'opérateur Page 84